KISS 2-4S 18a ESC

" We only recomend this Flyduino high performance ESC to experianced solder tech's and pilots.. Apart from there mind blowing performance you need to be aware of the risk that these are very addictive "

KISS - Keep it super simple.the 18A Version use higher rated top notch fets (originals) which are able to withstand higher currents.
Smallest ESC in its class, just 2g bare PCB.

Hardware and Software are developed for each other, all Parameters are optimized, we are sure you wont find another similar sized ESC which stays as cool and react as fast as this ESC at the same Ampere draw.
Due to this special integration of hard and software some features are realized which allow the ESC to peform at a real high end level, no one reacts or brakes faster on a 14 Pole Motor (quite common) RPM up to 42.000 are supported, which is simply amazing.
Given this high Pole count Motors arent a problem too for this ESC too.

Oneshot125 is an alternative PWM throttle Signal that is 8 times shorter/faster then the Standard 400-490Hz signals are. It is meant to be sent instantly after each FC controll loop to have the fastest possible ESC Response.

Oneshot Signal transmission is deeply integrated in the ESC and is a flawless experience by just setting one solder jumper (just optional, normal PWM works of course too).
The Kiss ESC is easy to use, you wont need to do long test runs to find good settings, the Kiss ESC simply work.

Includes:

1x KISS 18A ESC version 1.1, assembled board , bare PCB (New Version 1.1 with bigger solder pads)

Things to care for:

Please calibrate the ESC in the normal PWM mode (this must be done one time at a set of ESCs) .
Do not directly mount the ESC on conductive material such as carbon fiber or aluminum.
Depending on the configuration, they also need GND connected instead of only the signal for FC because especially at 3.3V CPUs ( ARM Cortex for example ) a clean GND reference can be useful.

features:

Developed for Multicopter
Very small dimensions (12 x 24 mm)
Precision speed control (about 950 steps)
adaptive Auto Timing
32Khz PWM Frequenz
-0-500Hz input signal(PWM) or oneshot125 (up to 2000Hz)
no external Cap (electrolytic capacitor) is necessary **
fast reacting gas change
linear throttle response
Active freewheeling enabled (little diode losses resulting in higher efficiency)
Regenerative braking, therefore quick throttle response when decelerate (the ESC uses active freewheeling and regenerative braking, 2 independent features which relates to each other in different working states)
very fast FET switching through the use of special gate drivers
Minimal dead time, setted adaptive
2-4S LiPo capable
LED onboard
JP1 open : normal PWM (50-500Hz)
JP1 closed: oneshot125 PWM
JP2 open: Motor rotates in one direction
JP2 closed: Motor rotates in the other direction

(**) For very long LiPo power lines (more than 20cm) or to smooth out the supply, a 100 -

220uF Low ESR capacitor can be attached to the Lipo power pads.

manual

This Device is ESD sensitve, take precautions in any way, this is no "your coffee is hot warning", its physics we cant avoid, the smaller electronic becomes, the more ESD sensitive it is.